Recent content by claytoncarney

I checked the specs also and yes these Formbot fasteners are out of spec. However, other stock I have (4.87 diameter) has only a very slight bite. Perhaps that's by design, I'm not sure. I can say that other components designated as threaded in plastic have definitive characteristics. The A and...

Printed in Polymaker ASA on a Prusa Mini with an ad hoc chamber (45-50°C). The hole is not large enough for a 5mm drill bit to pass, but the screw slides with little to no resistance.

First build. A bit confused here... On page 48 of the manual. I assumed that the M5x30 BHCS was screwed directly into the plastic for retention. However, I found no bite on the printed part. I checked the STL and it indicates a screw hole 5.0mm diameter. I measure M5 at around 4.75mm diameter...

I've searched, but can not find any specs for the Exhaust Filter Material for the Voron 2.4 (as shown on page 283 in the Assembly Manual). I am NOT referring to the Nevermore system or any of the other similar mods available. It's the stock exhaust by VoronDesign. It's the 'Fume Extractor...

Still very early in the research stage of building a Voron v2.4. At present printing my own parts in ABS is not practical. So, I'm considering Print It Forward. However, I'm considering purchase of an LDO 2.4 300 Kit (likely Rev C). The LDO Printed Part Guide indicates that many of the...