Recent content by daduke

I agree. I'm running out of ideas.

after a few successful (straight) prints, I now had another crooked one, with the LED effects off. I really don't know what's causing this. If it were a mechanical problem, I'd expect it to occur in both directions, but it's either perfectly straight or leaning in positive X (and negative Y).

I might have a possible lead: maybe I went a bit overboard with the RGB lights. Since disabling a bunch of LED effects, prints seem to be straight again. To be confirmed...

you are correct of course. What I meant to say: I used mesh leveling via clicky to adjust the bed as perpendicular as possible. As mentioned in the first post, I also get straight prints from time to time, which tells me it's not a "the whole printer is crooked" problem.

yes, I have a clicky and did a mesh level. First layers are fine.

small update: started with a fresh Orcaslicer profile (was using Prusa before), same issue...

thanks for your suggestions! I have no reference how easy the head should move, but it seems ok and uniform yeah I did that and found no problems. I've also redone a good part of the motion system. Also: shouldn't increasing the stepper current make a difference this these two cases? it...

Dear Voron masters, I built a 0.2 (Siboor kit) and it works beautifully. I have one problem however: some prints (but not all!) come out crooked - they're not straight in neither X nor Y. I don't think it's frame related (since others are perfectly fine), and the combination of X and Y makes me...