VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by desmond007
-
D
help ! Squished layers from 5mm to 12mm
Thats likely it. I was modding a creatlity CR-KE hotend as a inexpensive but high value hotend. Thanks again - My son's windturbine is finished !- desmond007
- Post #5
- Forum: Voron V2.X
-
D
help ! Squished layers from 5mm to 12mm
Solved ! My heightmap was totally messed up. Printed the same cube with bed_mesh_clear and manually tweaked the height and it worked. Thanks so much ! Just need to figure how the map was so messed up. The variance was fine but the it was about 5MM floating above the base....- desmond007
- Post #3
- Forum: Voron V2.X
-
D
help ! Squished layers from 5mm to 12mm
After happily building and frequently using my Voron 2.4 R2 350 i have been vexed with this layer issue. For example, when printing a 20x20x30 cube i get squished layers from 5mm to 12mm. This means that the layer height in this range is much smaller than sliced (.2mm) and the side bulge...- desmond007
- Thread
- Replies: 4
- Forum: Voron V2.X