Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Just recently my printer started making a clicking noise when feeding the filament. I checked to make sure that the filament had no restriction, disassembled the gear block and examined it but could not see the cause of the issue. Anyone else have this problem and any ideas of what to try?
Found that the hotend temp sensor had a very intermittant connection at the hotend. Shutdown was due to the sensor dropping temp. Fixed it. Thanks for you help.
Interesting, I didn't think of watching the graph. It does show just before it shuts down that the temp starts to drop. I'll have to put my voltmeter on a different points to see where it's failing. Thanks
1/2 way through the print job Klipper shuts down with error "Heater extruder not heating at expected rate" and Klipper shuts down.
I am running Voron v2.4 printer with a E3D Revo Voron hotend printing with ABS filament on a Honeybadger plate.
Heating Bed at 110 Celsius and hotend is set to...
I have tried various hotend temp settings and 230 works best for this hotend.
With part cooling turned on it fails right at the start.
I have tried printing a single item (pix 2) and it still failed.
The printer is in an enclosure to avoid any cool air drafts.
What type of tuning (filament...
I am building a V2.4 printer and am trying to print the skirting. I have run through the calibration process and every time the job starts it fails shortly into the job. I get strings that get caught in the moving head and it either rips the object loose from the bed or gets tangled up and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.