VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by Doogle
-
D
EBB SB2209 CAN V1.0 (RP2040) + Voron Tap = Will not trigger Z endstop
Thank you! I've re-crimped some shorter connections and now have tap fully connected to CANbus board again, only the CANbus cable and PTFE tube going out of toolhead. Looks much better now.- Doogle
- Post #5
- Forum: Electronics
-
D
EBB SB2209 CAN V1.0 (RP2040) + Voron Tap = Will not trigger Z endstop
I ended up working around the issue, getting 5V and Gnd from the EBB RP2040 and using one of the wires from my old drag chain, wrapped it around the CAN cable back to my Octopus v1.1 for the signal pin instead.- Doogle
- Post #3
- Forum: Electronics
-
D
EBB SB2209 CAN V1.0 (RP2040) + Voron Tap = Will not trigger Z endstop
I am having quite the difficult time troubleshooting why Klipper will no longer trigger the z endstop no matter what I try... Tried shorting gpio21 directly to gnd and no change within Klipper. Also tried connecting to gpio22 and gpio6 but nothing will get Klipper to trigger the z endstop...- Doogle
- Thread
- Replies: 6
- Forum: Electronics