Recent content by Dump_Truck

From what I recall, yes. It's either 3b or 3b+ that this cropped up for. Now I'm curious if a 4 will exhibit the same symptoms. Might have to mess around with one of my other printers for that.

UPDATE: Yes, the 32bit os seems to have been the magic bullet that saved the printer and got it running again. I loaded the 32bit debian bookworm lite, used Kiauh to put everything I needed on it, threw my configs at it (edited them a bit) and fired it off. Multiple solid prints without issue...

Well I'm incredibly glad I decided to stop in, and even more happy that someone had a solution. Congrats on the fix, and I'm marking this as solved as the 32bit OS fix seems to be the ticket. Was running it on mine and actually finally got some solid prints out of my beast of a printer.

I'm tentative to offer a super solid yes, but I did switch to a 32 bit, and have had multiple prints succeed, most of them have been in the 4hr range so far. It's more positive than anything I've gotten out of the 64bit OS so far.

Haven't redone my OS yet, it's Going to be soon, as everything else is failing miserably. I have another Pi 3 that I'm going to use to build the 32bit os, and then just swap the SD cards and fire it off, see if it plays ball that way. I'd do it now, but someone is looking into the issue with me...

I can't say my raspberry pi is that old, but I don't know how long it's been on a shelf. I got this voron as a vivideno kit 3-4ish years ago? But I'm getting me a pi 4, cause I was supposed to get my kit with a pi 4, but that huge shortage got me. That and with pi5 being out, pi4 got cheaper...

Well friend, I have a new project for tomorrow and this weekend then, cause I just redid my cable (Again, and again and again.....) and after I did, every possible error, warning, and problem started appearing. Time to rip it's brains out and try again!

So once you can see this (Moderator approval needed since I'm new on here) I have the cable that came with my SB2209. I have no way to tell if it's shielded. I assume it is not, mine is run literally outside my printer entirely away from my Z driver wires. Made no difference. I'm waiting for my...

Doesn't like 64? Well dang, cause that's what I installed too. Well it looks like we have a project. Keep me posted, I'll be thrilled to hear back.

Just recently started having issues with my wiring harness with my SB and CW2 on my V2. So I figured since I'm going to be doing this mess anyway, figured I'd go CAN Bus instead. (Edit: Followed the excellent guide by esoterical for this) I am rapidly coming to the conclusion that I have made a...