Recent content by EndlessHunt

Hi, I've switched to SuperSlicer and have been playing with settings. Improved the bridging but still need to work on overhangs First layer still need some work done and got the top layer a lot better as well Any advice on how to improve tings further would be welcome.

Thanx, was slowly getting to the same conclusion. I need to do a systematic and complete run through/tuning of the printer. I have never before had to do proper bridging as I always avoided prints with it, or just lived with the bad bridging. I now want to solve it for my own betterment but do...

I did figure out that these corners was my pressure advance that was to high Dialed it down and now it looks better

PS. IT is a open printer so I'm not using any part cooling at the moment

Hi Sanity, S3D does detect it. It is the areas coloured yellow in the image below. I just do not have a clue as what to tell it to do with the bridges. This is my setting at the moment

Hi. In general I'm quite happy with my settings. I'm printing parts for my LDO Voron 2.4R2 300. I'm using Simplify3D 5.1.2 and are printing the parts on my Anycubic Kobra Go that I'm running on Klipper/Mainsailos. Basic setting give an acceptable quality at this time considering it is the...