Recent content by EricZimmerman

1. yes, 4 wires total. its great 2. different form factors, like an EBB36 for a pancake motor, or an EBB42 for square, etc. theres also different manufacturers, but in general for form factors are the same 3. not on all. the mellow can to a degree, but it has its own issues. generally you can...

yea i run it on the 2.4. its AWESOME. cant say enough good things about it. https://github.com/EricZimmerman/Voron24/tree/PreKlippain/adxl_results/inputshaper

incorrect! hehe

Initial question was "what are the effects of changing microsteps in printer.cfg?", directed at MallCop. MallCop then provided the following details: A stepper motor is a brushless motor. Brushless motors are harder to drive because they require a "wave" of magnetism through them to spin the...

ill have to try the thin version!

always good content, right to the point!

can confirm this one works great, but i needed to use the omron adapter for euclid to be able to adjust things back to the dock.

This method works amazingly well to dial in the PA. Let the lines get you close, then do this method until you get the perfect lines.