Recent content by evan

Thank you majic79! I will try your approach over the weekend. The frame is definitely square, or at least no more than 0.5 mm out, which I am assuming is ok. I believe I read somewhere that up to a mm out is ok.

And a picture of my current process.

Hi all. A year ago I completed my Voron Trident300 (LDO kit). But I never did solve an issue I had with it, see here for details https://forum.vorondesign.com/threads/extrusion-or-bed-level-trident-300-build.715/ Because of the above issue it has sat unused for 6 months or more, can't remember...

Unfortunately i never did resolve the issue. :ROFLMAO:

.... a few days later. Well, very happy to report - for the past 2 days I have been printing both ASA and ABS successfully on my Trident 300. Almost perfect first layer and prints across the whole bed. Keen to work out what the issue is but for the moment I'm not touching anything as I need to...

Yes, same as for KlickyNG and Omron inductive.

I much prefer Klicky over the Omron inductive specified in the BOM. Have tried both without any luck fixing the first layer. To me it felt as though Klipper bed mesh was not compensating in the correct way or area. In fact, I was getting marginally better first layers without bed mesh. But the...

Hey jetttttttttttts. Sorry to hear you are having the same / similar issue. It's frustrating. I have had my trident for almost a year now but so far have been unsuccessful in printing anything substantial on it. Saying that, I was reading the Klipper documentation again a few days ago, and came...

Thank you! I am using Klicky Probe NG. I have attached a zip of the printer cfg as well as the included macros (klicky variables, print start, etc)

Me again........ o_O Well, seems I am still having the same issue. For the life of me I just can't work this out. I have tried probing more points, from 5x5 up to 9x9 as well as different smooth points and algorithm. Nothing seems to make a difference. I can see the lead screws adjusting /...

Thanks to the both of you! I purchased the LDO Orbiter V2 so my guess is I have the correct / exact motor. But for now I will comment out those lines and try. I did not think to look on the TMC website, so thank you NoGuru.

Hi all, I have an Orbiter V2 mounted on a DragonBurner and am trying to understand the recommended klipper settings that are suggested on the Orbiter product website. The last four lines of code really.... I can seem to find info on the klipper website on what they do. Are they needed? I'm...

Finally parts are staying down 🤞 thanks to all for the suggestions / help. Second medium sized print is now running successfully with esun ABS+ I'm hoping I can now finish off printing the remaining external parts and nevermore filter. To be honest, I have no idea what the problem was. I tried...

I will try the opposite side of the sheet, which is textured. I think from memory when I first attempted to print ABS on that side it also had issues with sticking, however that was before I had fully enclosed the printer. I have no other smooth PEI sheets. Just wanted to quickly add - I...

It's been a difficult one for me to diagnose. Depending where on the PEI I print it either sticks very well or not very well. I played around with thumb screw tension yesterday and thought there was some improvement so continued to tune some abs filament (esun abs+) . Started a more substantial...