VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by Evilmonkey
-
E
Homing X gives up before reaching endstop switch
- Evilmonkey
- Post #5
- Forum: Voron Zero
-
E
Homing X gives up before reaching endstop switch
Endstop switch. This only recently started happening (a week or 2 ago). I hadn't changed anything in my printer.cfg at the time. I upped my X amps a little after it started happening, but that didn't help. I think it may have started after I got a "MCU 'mcu' shutdown: Timer too close". I'm...- Evilmonkey
- Post #4
- Forum: Voron Zero
-
E
Homing X gives up before reaching endstop switch
TIA I'll see if I can post of GIF or something of it later, but: Unless I start with the X position close to the limit switch already, when homing X my 0.1 will move the toolhead in the positive X direction for about 10-20 mm, then give up and give me the error "No trigger on x after full...- Evilmonkey
- Thread
- Replies: 4
- Forum: Voron Zero