Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Tks for your comments. Upon further investigation I found that my part cooling fan wires were pinched and it stopped when printing. I fix that and my printing quality is back to normal. Thank you all
Hello All Having issues with over hang on my voron 2.4 350x350 with a dragon HF extruder and my hotend and extruder fan are both at 100%. Not sure how to address this ?
Thank you for your response very appreciated. I have solved my problems I did not set the z end stop position correctly. So I guess I did not follow it properly!
Hello Everyone,
Having issue with my z homing on a new build. I have managed to home x and y but when I start the Z homing the gantry go up a bit (probably 10) and stop with this error: Move out of range: -10.000 -10.000 10.000 [0.000].
Been butting my head for the last day on this one do not...
I have an btt octopus 1.1 and a btt mini display 12864. It is not even having a backlight on although it did before I flashed the firmware.
here is my display from printer.cfg
Can anyone point me in the right direction ?
#####################################################################...
I just finished building my new 350x350 Voron 2.4 with a raspberry pi 4 2gig, octopus board, I managed to test all motors and successfully homed X and Y. However when I try to home my Z axis the gantry goes up by 10 and give following error message Move out of range: -10.000 -10.000 10.000...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.