What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by frodo5343

  1. F

    Question Z-wobble, but only with some models?

    Thanks for the suggestion. I ordered a cnc tap to install when I replace my belts so I'll see if that helps too
  2. F

    Question Z-wobble, but only with some models?

    Just to update this. Here is an example where the simple part of the print printed ok, but the more complex portion looks terrible. I think I'm actually dropping steps based on looking closer. The head moves just fine, so I'm not sure why I'd drop steps, especially since I did tests where...
  3. F

    Question Z-wobble, but only with some models?

    Hello all, I upgraded several months ago to tap and stealthburner and have been having intermittent issues since. I first noticed it with this model. https://1drv.ms/i/s!As3BjAMCoBAWi84sMYw1ZXiPRIMIGw?e=nRuwe5 I printed a bunch of these and the z-wobble issues weren't exactly in the same...
  4. F

    Tap always registering as open

    Hello, I'm upgrading my 2.4 to tap and the z-endstop isn't being recognized in klipper. The light on the PCB board stays red even when it should trigger. If I swap the signal and ground from what they should be, the light will toggle when trigger, but klipper doesn't register it when using...
See more
Top