Recent content by Ingold

Thanks for the info, and the link. I am not 100% sure about the wiring but I am sure I can work it out, with some googling and a continuity testing. :)

Thanks for that. It makes a lot of sense; essentially, I need to buy a new board with an actual USB connection and throw that one out or break it down for parts.

Mine still does it, I got fed up and disconnected my display.

I found the same, except for the hub. All others point to the cable; I disregarded them because the display has been working fine for over 30 hours of printing, and if it were a faulty cable, it would also error out while idle. If it was the hub, then the other USB device (WiFi module) would...

Its a 4PIN at the back type board, which I now want to be a micro-USB because I could easily use another USB cable. :( I triggered the shutdown by running a heatsoak for 20 min, then kicking off a long print. It didn't even make it to the purge line. This is as much useful info I can get...

I have a weird problem with the V0 Display Board. It worked fine for over 2 months of printing (roughly 30 hours of total print time according to Mainsail), and then it started timing out and I got the MCU Display timeout error. I upgraded the firmware to v0.11.0-235 before I started my first...

Make sure the little flathead bolt you put in is screwed all the way in. From the photo, it looks like it screwed all the way out.

Let's not get me started about my 2-year-old 2.4 formbot kit build; it has a full rebuild in its future where everything that is "generic" gets replaced; I can't even find the Spec Sheet on the motors. So many things that are just F(&*(&*ed about it

I replayed the video, and it hurts my brain too. I did notice your stealthchop is at 200. Did you set that to 0? I turned stealthchop on once, and the noise made my ears bleed.

That sounds like you have interpolate off on your stepper settings in your printer.cfg. But by the sounds of it, it is off for some of the drives and on for others. I turned it off on my steppers and I hear the same noise, I don't think it hurts anything just noise but more accurate.

Mine has evolved as I have done the upgrades, but here it is for you. I like to comment on changes. [gcode_macro PRINT_START] # Use PRINT_START for the slicer starting script - please customise for your slicer of choice # Start GCODE should be : print_start...

I have been trying to resolve the same issue; here is what I have done: Nozzle Cleaner installed, setup macros to brush the nozzle after the extruder reaches its temperature and before it performs any calibration actions. Installed Euclid Probe and configured Configured AutoZ Configured...

I spent hours trying to get the right "twang", I am no guitar player and every time I plucked the same belt with no adjustment, it sounded different. I have probably over-tightened them; I am quietly waiting for the whole gantry to collapse from the belts being over-tightened, but up until...

I found the same thing using the Omron probe, I set the camber to be 50c, but by the time QGL activated, my chamber was 60, and it failed every time. My Solution was to set the Chamber Temp to 40 before starting the print, by the time QGL & Adaptive Mesh run the chamber is 50. Seems to be...