VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by JamesFMB
-
J
Voron 2.4 No Extrusion
Hi there, I have just finished building my Voron 2.1 R1, but I can't get it to extrude. The extruder is pulling filament in, but then it seems to clog as it goes into the hotend. The hotend is 240 degrees, so I'm guessing it should be melting the filament when it gets that far, is that right...- JamesFMB
- Thread
- Replies: 1
- Forum: Voron V2.X
-
J
How to fit the PTFE tube in place on the Clockwork - Voron 2.4 R1
That's very helpful, thank you. I'll try stuffing it in. Thanks James- JamesFMB
- Post #3
- Forum: Voron V2.X
-
J
How to fit the PTFE tube in place on the Clockwork - Voron 2.4 R1
Hello, I have a couple of questions about assembling the PTFE tube on my Voron 2.4, would it be possible to have some help? I can't figure out how to attach the PTFE tube to the top of the clockwork on my Voron 2.4 R1 print head. It might be because the printed part I got is slightly deformed...- JamesFMB
- Thread
- Replies: 2
- Forum: Voron V2.X