Recent content by Jerlin

I'm using a "wansview webcam 1080p 102". Just a generic marketing name, the 102 seems to be the model number. (The ASIN is "B087M6YNYF", I'm not sure if links to amazon are allowed here) The thermistors are connected to the spider controller board, they are specified via "fan" and shown in the...

Hello again, I want to give an update about my "Newton": The electronics compartment has its own thermistor RGB lights, check I used 45° aluminium extrusion with custom printed mounting caps webcam, check the mount is not final, I am not really happy with the angle chamber thermistor, check...

Did you check in and out of the neopixel? Otherwise the whole chain would not light up. (I learned that the hard way :) )

If your prints are running fine, and you are seeing any belt wear on your pullies, I would stick with that values. Also, it is much more important, that your belts are tighten evenly, than the exact amount of torque. Just check regularly for wear. My x-value is slightly higher, than the...

Are you getting reliable measurements around 110 hz? I have tried it many times, and was not able to hit it consistently. I was always ending up with to tight belts. My method is driving the print head with high acceleration, while looking at the pullies. When the belt behaving like a car on...

Well, Both are Core-XY, with many in common. I would say the dual a/b motors are the main difference. they should apply to higher printing speeds, if the whole motion system is from good quality. on the other hand, more parts mean, more possible point of failure. About part-spec and selection...

Hello to everyone! I got myself a nice christmas present, a Voron Trident 300 Kit by Fysetc. The build went straight forward, all thanks to the documetation. It was my first printer kit, but i already own an Ender 7, which I slightly modified (Klipper+Klipperscreen, Mosquito Hotend, drag chain)...