Recent content by JohannW

Ok, I'm completely lost. I still cant wrap my head around the fact that electrics were allowed to call 2 different things by the same name. For the wire harness Gnd is attached to V- on the Supply. When I test continuity between the Gnd (V-) (All wires connected to the board) When I test...

Yes I have the X/Y endstop pcb. And the Octopus V1.1

So, I'm getting continuity, and when I test the switch nothing happens, but when i test the switch its self it works. The X Jst connector to the board has 3 wires, the Y and ABL jst connectors have a single lead goes to the bottom pin insted of the center pin, the Z jst (the only working stop)...

I hope this helps.

how do i get the file out of mainsail? the x/y has continuity, but IDK how I can test the probe the Fan I will test tomorrow when I can take the tool head apart.

I copy and pasted the LDO motors Voron 2.4r2 printer CFG revision A version from GitHub, Via the instructions on the "Build it Basement" ultimate voron build series on YouTube, and then added hashs to the chamber thermistor section..... the bed and hotend and XYZ motors respond, as well as the Z...

hopefully this photo helps

Is there anything I can do to change the size of my photo to sub 1MB ? My pictures are nearly 4MB a piece.

when I try to attach pics it says the file is too large. IDK what I'm doing wrong

I'm having an issue with my: X/Y endstop (passes continuity test but remains triggered/open in mainsail) I've tried adding ^ and ! and combinations of both in the printercfg. PL-08N style probe not responding. Fans not turning on (only one fan shows in the dashboard) p.s. I am using...