Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
I was suspecting that the Chaotic Labs TAP was allowing the print head to lift as it was printing. To try to prove (or disprove) this I setup a bracket that attached to the X-endstop switch mounting holes on the 'fixed' portion of the CL tap. This bracket then reached behind and over the...
Thanks for that suggestion.
I did manage to get the first layer issue resolved by increasing extrusion on the first layer. The lifting wall also eventually went away, but I didn't do anything specific to address it (?)...
I switched over to ASA filament and it was printing well... until I...
Even obvious suggestions are appreciated! But I did give the build surface a good cleaning after my first attempts and haven't found any improvement.
The build surface is an early Fysetc textured PEI steel flex-plate from the original hypercube. It has provided years and years of great service...
Hi all - looking for some suggestions on what might be causing a couple of print quality issues I'm seeing on a fresh Trident build...
This printer is my second Voron printer. The first was a V2.4 which I completed a few months ago and that printer has been running great from day one. This...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.