Recent content by lizzardWizzard

Its work with another port. Problem is broken fan wire.

Somehow i manage to break part fan wire when reassembling heater. So when it run all shut down. Solder the wire and its work fine thx.

After disassemble i found one pin is broken. I replace it and it work. Thx for answer anyway. Bye until my next stupid fail :)

I have two exact the same Nema 17 moons ms17hd6p420i-04 for X and Y. One day one of them(X) stop running properly. First video Y motor. Second video X(broken) motor. Is it any way to fix it ?

Yep i tryed another different cable\ports its not working. This morning i reflesh PI and have sad situation(my another thread:)) Now i rewire my whole setup in better way and also check it for any kind of burn or smth. I order another octopus and raspberry pi 3 instead my btt pi. But before i...

After flashing new mainsail on my btt pi 1.2 somehow burn my fan0. Before this fans work fine and after flashing i start with testing my printhead. Hotend and hotend fan work fine, then i manually adjust part cooling fan and its burn out. First i cant understand why its happen and is this...

Hi. Recently i finish assemble my Voron 2.4 R2. All test (homing, autoleveling, pid) is fine and even first layer of print is fine, but when printer change layer from 1 to 2 i get Lost communication with MCU 'mcu' with b'Got EOF when reading from device' in klipper.log So basicaly in my case...