Recent content by maestro

Finally, it looks like I resolved the issue. The root cause, most likely, was not in the hardware. I'm using Armbian as an OS on my host, and I had an issue with its configuration. During the initial setup, I had a problem with the networking settings, and it did not work properly. I...

Thank you for the suggestion. I have not thought about it. That is a good idea, and I probably need to get a BTT U2C USB-to-CAN interface to try it. I will post an update here once I get one. In the meantime, I have also created a GitHub issue for BTT, but I have not received any replies there...

I'm experiencing a random connection issue and am seeking assistance with resolving it. I have a Voron 2.4 Formbot kit with BTT Manta M8P 2.0 + CB1 connected to EBB SB2209 CAN V1.0 (RP2040) via CAN. Randomly, during the printing, I'm getting an error "Lost communication with MCU 'EBBCan' Once...

Thank you for the reply. But after spending some time on this, I finally figured out what was the issue. Unfortunately, I was confused by the board version and pinout diagram. I have the board V1.0.1 which has a different pin naming from V1.1. But in the GitHub repo BTT put diagrams for both...

Hi All! I've just finished building my Voron V2.4 based on Octopus Pro (STM32F446). According to the wiring doc, I connected my hot-end heater to the HE0 screwed connector (PA0 pin). When my assembly was complete, I started testing the heater. I set the target temperature to 50 degrees...