Recent content by majic79

I guess heat creep is another consideration - didn't CNCKitchen make a V0 with CF ABS and it just moved around the CF fibres and turned out to be a very bad idea in the end? Would glass filled behave the same way or differently?

I bought the BTT EBB36 kit and got it with the PT100 amplifier included - this lead to problems mounting on a MiniSB tool head (Voron V0) and I had to find the perfect mount to clear the amplifier. If you don't need the PT100/1000 amplifier, don't get it it (MAX31865). The kit came with pins and...

can you share your printer.cfg?

Here are my config sections (Trident 300x300) [bed_mesh] speed: 150 horizontal_move_z: 5 mesh_min: 30, 30 mesh_max: 270, 270 fade_start: 0.6 fade_end: 10.0 probe_count: 5, 5 algorithm: bicubic zero_reference_position: 150,150 [gcode_macro PRINT_START] gcode: G28 Z_TILT_ADJUST...

Before you do calibrate, run the bed level command 'Z_TILT_ADJUST', then re-home 'G28 Z'

Ok - as an ex-software engineer, I left myself open to that one!

Anyone seen this? I'm running a print project that needs >100 pretty much full bed parts, being able to auto eject would be very nice...

Fortunately the film was on the smooth PEI side, I've been printing on the textured side (after cleaning of course) with no adhesion issues aside from a wandering low spot...

Makes you wonder how they can get it so wrong if they are all copying the same code

I agree - I had massive hope for it.

This is the mount I used on my V0 Mini-StealthBurner EBB36 board (mine came with the MAX31865 chip for reading a PT sensor - not all brackets have clearance for that, this one does): https://www.printables.com/model/351128-ebb36-strain-relief-bracket 8/10, would recommend - only thing I...

there was a lot of people calling to jump to OrcaSlicer - so I gave it a try and I was disappointed. At the very least, I expected it to perform as well as SuperSlicer, and I had nothing but problems. Half of it was definitely a new workflow in Orca, so that's on me, but when I did finally get...

Just checked my V0 - yep, did the same thing there as well! That one didn't ruffle up though (nowhere near as many hours on that though)

Been printing away on my trident for some time now and a friend asked me if I could look at a small print job for them - no problem. Everything is running well, the only thing I'm unhappy with is what appears to be a low spot on the bed, but I can work around that. Started printing out parts...

Try printing PETG and you'll appreciate that integrated heartbreak even more - no matter how well you tighten the nozzle, PETG will, uh..., find a way