What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by merc718

  1. M

    Solved Adjusting z-off set and z endstop

    Solved: Cleared Mesh. Cleared both offsets. Redid offsets. redid mesh. works fine.
  2. M

    Solved Adjusting z-off set and z endstop

    i did probe_calibrate and Z_ENDSTOP_CALIBRATE. saved the results. However, my nozzle is still approx 5 mm above the bed when starting a print. Even when i adjust the nozzle during a print, save it, and start a new print, its still starts a print at the same height. Any help is appreciated.
See more
Top