Solved Adjusting z-off set and z endstop

[merc718]

Printer Model

Voron 2.4 LDO

Extruder Type

Galileo

Cooling Type

Stealthburner

i did probe_calibrate and Z_ENDSTOP_CALIBRATE. saved the results. However, my nozzle is still approx 5 mm above the bed when starting a print. Even when i adjust the nozzle during a print, save it, and start a new print, its still starts a print at the same height. Any help is appreciated.

 

[merc718]

Solved: Cleared Mesh. Cleared both offsets. Redid offsets. redid mesh. works fine.