VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by MikeD
-
M
Voron 2.4 R2 - Fix Print
This is where we are at. Using OctaSlicer pressure advanced. Does not no look good.- MikeD
- Post #5
- Forum: Slice and Print
-
M
Voron 2.4 R2 - Fix Print
Ran through Ellis guide again but took my time this time around. Same results afterwards. Could it be something with the hotend? It was printing pretty decently after the build with minor tuning then I had a catastrophic failure. PLA everywhere. Hotend was covered. I might take the dragon...- MikeD
- Post #4
- Forum: Slice and Print
-
M
Voron 2.4 R2 - Fix Print
PusaSlicer sunlu ABS Nozzle 255 Bed 95-105 Print Speed - Nozzle Retraction Settings - I've tried different bed temperatures. Fan/no fan. Adjusted Z offset. I've let the print cool down for an hour before opening the chamber door. Help me!!!!- MikeD
- Thread
- Replies: 4
- Forum: Slice and Print