Recent content by mocho

Hello, I am having problems with savox servo calibration. When I put MMU_SERVO POS=down it does not pass the moving channel. When it's powered against the top hat, fillament is enganged but after some (3/4) seconds it powers down, have a little "backlash", get's back to move channel and...

Thank you qvD. I have 88 caselight RGB (without white) neopixels. Using your macro, only modifying the name it works to toggle it. Many thanks and best regards

@Yezariael, Thank you but as I said before I could already do an On and an OFF neopixels trough two macros. What I need is a Macro that if neopixel lights are OFF turn them ON and if they are ON turn them OFF! I need a TOGGLE macro! It as to be the same macro so I can invoque it with the same...

already looked beafore. there is no macro to toggle ON/OFF and that's what I need to make button work

Hello All, I've put some gcode buttons on my 2.4, Switchwire and 0.2 but the macro to toggle lights with buttons that I've found online all use output_pin to activate gcode like: ##################################################################### # Caselight pin Definition...

ok. that makes sense

I Only had this with PT100. It would spike and came back "slowly" to normal values. Same board with Semitec 104GT-2 no spike.

ok.... After thinking a little more I see orientation of belts are not the same of 2.4 and trident. It would need a changed plate? Maybe?. Any CAD expert willing to do it?

I've seen some documentain that TAP was available for 2.4 and trident. It should be possible also with Voron Switchwire right?

FINALLY!!!! A searchable and followable source of information, support and discussion related to voron!!! THANK YOU!!