Recent content by Moofy

photos

Octopus 1.1 used the voron 2.4 config file and figured out how to set for 350 build would it kill machine if I plugged spare thermistors into the main board and set them in config to see if there is a wire issue

afterburner pcb board with diode on board

not totally sure thermstor on heat bed the hotend is a revo 1st gen set this is a freash log

klippy log

new build self sourced. wires checked. went thru config but missing something i do have klippy log and my printer cfg file avalable

any help or direction welcome. wires checked and look good. 350 self source build. Klipper reports: SHUTDOWN MCU 'mcu' shutdown: ADC out of range This generally occurs when a heater temperature exceeds its configured min_temp or max_temp. Once the underlying issue is corrected, use the...