Recent content by Mr.Jiggles

So I fixed the problem, I replaced the HF for the Dragon ST. Now everything works fine. I print with low speeds and for that reason the HF got clogged.

@NoGuru -Yes, it is PID tuned -Extrudr DuraPro says 220 till 250 degrees? So what temp must i choose? -speed is 100mm/s -yes nozzle is correct, with no gaps -extruder is the clockwork on the latest Stealthburner. 0.65 current. What do you mean with Fillament temp tuned?

I have my Voron 2.4 now for few weeks running, perfect prints. But after few hours of printing the nozzle got clogged. To resolve this. I unclip the latch from the SB, remove the Bowden tube, the stuck filament is visible then. When pulling the tube I can wiggle it a few mm, to resolves this I...