Recent content by mstaniszczak

Thank you!

And... serial request :D

things that need fixing/rethinking: add a rear cover for the electronics — I ran out of filament :D the BTT SFS should be placed before the extruder, not after :D

Almost done!

And a few more pics

Thanks, guys :) I’m doing my best with the time and patience I’ve got. Today it’s more small steps — toolhead cabling, the Nevermore, and the screen.

Further work. Unfortunately in the v0 there’s no space behind the toolhead for a Beacon, a Cartographer, or even a shaved‑down Eddy… For now it’ll run without a probe, and we’ll see in the future.

a more ;)

A picture is worth a thousand words, or so they say ;)

I’m back! After a long break caused by a bunch of different things, I’m returning to the build. A few things will be different: toolhead: Yavoth extruder – Dragon Ace Raspberry Pi 4 instead of the BTT Pi - in the photos it’s still the BTT Pi a simple Voron V0 display instead of the BTT TFT35 —...

And a little more :)

And more

Little more photos

And little more :) I deciade to use MF nano, not nevermore, becouse of size. Also I decide to change hotend to Dragon Ace, becousew it's smaller than Rapido UHF and I can use Dragon Burner instand of Rapid Burner - from my poin of view, Dragon Burner looks much better in v0.

A lot of work, illness, a lot of work and once again a lot of work and v0 was on hold for a while, but I'm back to work :)