Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Yeah, i had one go out on me. One of the im assuming resistors on the pcb took a dump because everything was fine minus the Hotend Thermistor. All the contiunity was there between all the jst female connector and the 14 pin header. It the didnt allow the printer to boot up. Swapped it out and...
Its an LDO Kit so they are LDO-42STH48-2004MAH. I havent messed with voltages before as i never needed to not even on my 2.4 or V0. Ill look into it for sure.
Im having an issue with external walls not looking so good. Ive been struggling with it for a little while and cant see to figure it out. I followed Ellis's tuning guide to a T and tried my own tunes but I cant resolve the issue. I have made sure that the mesh for the extruder is good, tried...
I figured it out. The JST connector was cracked on the thermistor to the toolhead PCB. It wasnt allowing the pins to fully engage on the pcb. Thanks for suggestions fellas!
Sorry i worded that weird. What I meant to say was I moved the entire hotend from the trident to the 2.4 and didnt get the error after moving it. It only happens on the trident.
Hey guys I just finished my Trident 2 days ago and its been printing fine but all of a sudden I have been experiencing a "spike" in temp on the extruder. The temp doesnt actually reach 600c but it will be randomly spike to that temp with the thermistor then I will receive an error. My hotend...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.