Recent content by pajtaz

Hi, I am interested in helping out. I print a lot, I am in Europe, have plenty of filament, and I am also an engineer interested in the data that you can collect. How do we get in touch?

Yes there is but now sure how updated it is: https://github.com/hartk1213/MISC/tree/main/Voron%20Mods/Extruders/CW1_On_CW2_MGN12Carraige

It might just barely fit but how will you get it in and out? You need extra space on top and sides for your hands to grab the printer. It will not be enough. What will be just right is Ikea Metod kitchen cabinet, the one that goes on the floor. Additionally if you don't have any panels or...

So ... user error? I'm glad you got it fixed.

That looks correct. If you say wiring from each piece of hardware to the toolhead PCB is correct (quadruple check this) and from toolhead PCB to breakout PCB is correct and from breakout PCB to Octopus is correct then maybe there is something else going on with printer.cfg. Do you have two...

How did you connect the part cooling fan and what do you have in printer.cfg for part cooling fan? It sounds like you have configured the part cooling fan incorrectly in printer.cfg.

Sanity explained about lifting the panel, you get that now. Bed needs to be all the way up. As for insulating the deck panel, it keeps the heat away from electronics. Otherwise lots of heat will go to the electronics area since that deck panel is not sealed and ACM and not very thick...

Please let us know how the printed parts work out. Looking at the one photo of the printed parts up close, there are only 3 perimeters and they look wide, seems they were printed with 0.6mm nozzle. This is not per Voron printed parts guide which requires 0.4 mm nozzle and 4 perimeters...

Maybe I'm too late to add my thoughts but I do not think inverted electronics mod is a good idea. I did it on the first Trident and it is now more of a pain than on the second Trident where I went with stock electronics. I have put thick insulation on the deck panel to get higher chamber temps...

Mueller PEI and OSEQ. For Mueller PEI you need a spring steel sheet on which to apply this PEI. OSEQ is a double-sided one piece sheet.

I had massive ringing in X and some extra ringing in Y after installing Tap. No matter how many times I disassembled and re-assembled, ringing was there and high frequency spike around 130 Hz. HOWEVER ... after all this I suspected my X rail. I bought a new MGN12H rail and installed it. Well the...