Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Checked the TEST SPEED with 5000mm/s² and 50mm/s
It moves good.
But when I touch the toolhead the motor skips and does really have not much power.
Also checked the belts and the routing of them is correct. Not the wrong routing as described everywhere. Also lifted the back panel to be sure the...
i tried also at 0.8A and 1.0A but with the same problem. so to an advise of someone I made it higher. The motors should not have any problem, they also do not get hot.
They are rated at 2.4A.
But to be honest, I dont know where I should look next... I will check the routing of the belts again...
Hey all,
Since some time i got massive layer shift issues and now I'm at an point where i dont know what I should do.
Layershifts happen at different layer heights.
Sometimes the print finish without problem.
What I tried already:
1. Checked the mechanic, put off the belts and checked the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.