Recent content by Pradit

I think it's time due to submit serial request. Edited January 25 by Pradit

I'm planning for the smoke alarm and some sort of fire distinguisher. Does anyone have good mods for Voron2 to suggest?

OK Back to the lesson learned from the bad PLA and my noob knowledge in 3d printing. # Clogging This was the 1st clog for my printer since built. It's just DEFCON 3. I poke till it out of my Rapido. Still some stuck at the top I had to pull it out. I didn't learn then. It leads me...

I noticed my RPI temp go over 56 to 60c. It's time to put a fan on it. But I have no heat sink at this time. Decided to print this mod for my RPI3B+. But it was too wide meant to be for RPI4 I guess. I just Ziptie it at the end. Now 45-48c...

Like my woodworking, most of the time I'm building Jigs and tools. Here goes 3d printing... Mac support Paint pyramid. Screw meter Wood marking guage. Gridfinity bin

# Mod More removable latch. I realize I need 5.5mm not the 6mm one. Yet another canbus cable mount. I was on a journey to find holly grail. Silica gel container. This 2 hours+ print. This 1.20 hr print. What could cause this? I'm using arc_welder plugin too. I found the...

# Mod LED... It makes you print faster!!! LED mount. Continuity check. I'm getting a little bit better in soldering. It is quite confusing about RGB, WGRB, GRB, GRBW, LGBT.... How would we know what we are??? Finally with a good guide here...

I'm trying to get all my checklist done. There are still some more mods I have to print. # Mod The Roller help me roll the printer to get to work on the electronic part easily. Filament filter 270 door latch The_filter (nevermore contender).

Despite a bad quality new PLA I got. I had an opportunity to learn from all the mistakes and people helping me. I learned that I need to heat soak the bed for almost an hour before running QGL. Each brand PLA temp is different and have different behavior. Yet I doubt with the same brand...

Here goes the next upgrade and new spool from China. Black, Orange, Blue, Pink PLA. Small fan big fan thermistor pocco connector.

I've been avoiding using this auto retract keyring. But I could find the other way to handle this. I found this so mount it.

# VPN Remote access. Thanks to a discord user to introduce Zerotier to me. https://www.zerotier.com/ Now I could access it anywhere. Great.

OK Mate!!! Lets call it done!!! My 1st Voron 2.4 R2. Otherwise, it'd never be done. It could just keep adding and upgrading... I think I had more tools than the actual Voron's parts.

After I put together skirts, re-cable and wire, panel and stuff. The printer behaves strangely. I also had some octoprint plugins enabled too though. ie: Arc welder, thermal runaway, better graph, better time lapse, etc. Just to test the boot time that I had a problem with before. And this...

I used 1mm tape on the side panel without knowing that it needs 3mm. So the belt had no room with the side panel. I didn't order 3 mm at the time. Then I apply 2 more on top to make it 3mm. I had to reprint the latch with the 6mm version as well.