Recent content by Print3DWorld

I broke another Rapido (v1) this weekend, this time one of the screws broke inside of the heatbreak. This is my 3rd order for 100$ hot-ends. I am thinking about trying something else; either the V2 with easily swappable heaters/thermistors or the new Dragon ACE with Melt Zone Extender that is...

I have a weird issue when I enable this, even after reducing the retractions to 0, for some reason it retracts my filament all the way out of the extruder causing a failed print unless I manually load filament. I haven't looked into this further yet, but I am using an adapted config that I made...

These boards are super touchy to wiring issues, one of the FYSETC kits I got from them had an issue with the solder mask and ultimately died as well. I had to replace the LCD screen and mainboard on that one single kit. This looks like something on the 24v or 3.3/5V converter were an issue...

Kit is the way to go; and in the future you can upgrade with better rails and mods. LDO kit is top notch, FYSETC for budget friendly. Clean the linear rails according to guides online and you'll get good life. I recommend superlube grease for all PMs.

I would recommend using a pfSense machine and secure the whole network; cannot specify how much more stable and efficient my network is when I removed the ISP router/access point combo and enabled my pfSense machine with Unifi APs.. I had been installing them at work, and setting them up for...

Hmm.. I have one of those Dell tablets that run the Windows RT; I wonder if this would work for that thing, it's useless otherwise.

Spare parts are always best kept in my totes for printers as needed. Alot of times you run into issues like myself with the REVO, where you are like screw this I am putting my other hot-end back on while I wait for new parts or changes to be implemented (I bent the REVO nozzles twice in a week...

Hello all, I have posted this on several other places including the FYSETC github. I have a FYSETC 2.4R1 kit with the Spider 2.2 Board; all FYSETC stock parts. I upgraded to Klicky probe, sensorless homing (just like my ratrigs) and running the latest klipper version. I have had this issue...