Recent content by qvD

There is only a small change required to adapt the toggle macro from output pins to neopixel (Or other led versions). Specifically, you can access the status of the led using the color_data for each led: # Assuming you have [neopixel name_of_your_led] ... [gcode_macro CASELIGHT] gcode: {%...

Klipper has support for temperature_fan. This associates a specific fan with a temperature sensor and controls it similar to the way the hotend fan is controlled (either using a watermark or a pid controller). I'm using this to enable either side of my skirt fans based on the Raspberry Pi /...

TL;DR: Before printing the TAP parts, consider if your accent color is opaque enough to actually block the light in the sensor. After assembling my TAP, I had issues getting the sensor to recognise the tab on the center piece. At first I thought it was a configuration issue because the led on...