Recent content by Rat_Patrol

I have prints on my MK3 for the Voron, so this project is starting in earnest. Won't be super fast though, I have to balance printer time and work time with Voron time :D Anyway, for the config, (jumping ahead, I know), can I configure the chamber thermister to indicate whether to activate the...

Of course blue thread locker on the grub screws, but should all screws have a re-usable coating like vibra-tite?

Yes, I did get the square v2 filament sensor.

Regarding a filament sensor, I went ahead and ordered the BTT smart filament sensor. Is that a good choice? I'm honestly surprised that Voron doesn't have a filament runout sensor as standard.

I'm not sure with ASA CF, but I can get PETG CF much stronger than plain PETG simply because I get turn up the heat and turn off the parts fan. You would get the same increased layer adhesion with the same settings with regular PETG, but the stringing, sag and print issues would prevent it on...

Bought it from Matter Hackers for their Black Friday sale, so I don't even have it yet, but I wanted to know if there was any advice for before I even get started? I ordered the TAP kit with it, along with a Rpi from Matter Hackers. I ordered 3 spools of ASA from 3DXTech. Went with a red frame...