Recent content by Roman

Wrong port, everything works great I'd you don't mess up the hardware

So, I have recently been finishing up my 2.4 and adding a Mosquito Magnum hotend with stealthburner. The mod from printables seems to work great but on the programatical side I can't get the PT1000 thermistor to work. I have looked at different forms and videos but there isn't much on the...

Yes. It was the endstop. No it was just user error. Thanks

That was wrong i had changed the connectors and plugged the breakout end into the wrong port thanks for everyone's help!

So the issue is that the y endstop connection was bad between the octopus and the breakout board. In the times of trying to find the issue this killed the port on the break out. I checked the octopus connection by pluging in the x endstop to the y port and I did not get a short. And if you plug...

I found the issue the y endstop has an issue and I think it is with the connection I will replace the connector in the morning. Thanks see yall tomorrow

I can check fan polarity th controller fans turned on when I move the gantry via console but the tool fans still don't. That could easily be it

Sure it will be late tonight because I am at a event. Would a video be helpful

The thermistor works. I tried every HE port. The break out board only has one way to connect the wire. I'm talking about from the octopus 1.1 to the breakout that is where the wires are flipped. So if they are positive to positive and negative to negative then it shorts and the but as soon as I...

I am trying to get my LDO 2.4 350 working and I have a issue where the wires for the hotend have to be flipped otherwise it causes a short. And when they are flipped they supply exesive amounts of power to the hotend without user input. On mainsail it says that the hotend is off while the...