Recent content by SKIM3DP

Same exact issue...replaced my belts twice...have you tried the new idlers by any chance yet? 😅

i found out i just needed to reinstall moonraker and now it works great!

So my Voron 2.4 has been working great for the past month but just recently I ran into a problem. I needed to update a bunch of stuff (klipperscreen, moonraker, kipper, etc). So I updated it directly from the klipperscreen. However when I booted the printer back up I received this error message...

Yes i got it to work now! I noticed that when following the Voron manual it actually did it incorrectly (at least for me somehow someway)! Or maybe it could've been the Formbot Kit. Well anyways, I watched a video 3DPRINTERSCHOOL did on the wiring and now it works! The manual said to connect...

how would I know if I did? i am using a BTT Octopus v1.1

the commands came out with and error.

its connected to the 24 PSU on my Voron 2.4

i would however the message it gives me sometimes is with the y stepper, extruder, etc

the pins are defined correctly as far as I can see and the jumpers are in the right position

This is my first Voron and while trying to run a home command in mainsail this is what repeatedly comes up. I am very frustrated as how I can't find a definite answer. All of the steppers give the same result. Can anyone help with this problem?

ok i actually figured it out but thanks!

Has anyone installed a Tap on a Voron without a toolhead PCB? I'm struggling knowing how to connect it to the Btt Octopus....

Actually I think I figured it out...the Credit Card was somehow linked to my PayPal account that I do not use. Apparently the PayPal account needed special verification thus preventing the payment from going through. So...hopefully it will work now 🤞

I think ill wait just a tad before i cancel the order though...

when did you purchase it?