VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by Slimshader
-
S
Galileo 2 & BTT SB2209 CAN board
Ok, I found the issue, I needed to invert the enable pin on the motor. I got thrown off because I was battling with a faulty driver on a previous board and was convinced I'd already tried it but it seems not. All working now, so thank you for pointing me back to pin configuration!- Slimshader
- Post #4
- Forum: Voron V2.X
-
S
Galileo 2 & BTT SB2209 CAN board
Hi NoGuru Yes 24v is connected, and the hot end heats, fans run, probe and endstops work. In terms of the pins in the Klipper config, I replaced them with the ebbCan: pins as shown in the SB2209 manual for enable, step dir, diag etc along with the correct UART pin. The manual only shows the...- Slimshader
- Post #3
- Forum: Voron V2.X
-
S
Galileo 2 & BTT SB2209 CAN board
Hi, I'm upgrading my 2.4 to a BTT SB2209 tool board and am having issues with the LDO motor supplied with the Galileo 2. The motor works fine plugged into a motor port on the Octopus 1.1, but will not work on the SB2209 tool board. All other functions of the tool board are fine, just the...- Slimshader
- Thread
- Replies: 4
- Forum: Voron V2.X