Recent content by Stevi84

Hi Space King, mh ok but the inductive probe is for QGL and Bed mesh, and i have also an Z endstop siwtch where the nozzle tips. So the Z calibration makes me very confused. I think that the nozzle tip switch is for the nozzle hight and the induktive probe for QGL and bed mesh, after calibrating...

mh... i set in prusa an offest at general setting value of -,32mm otherwise my voron is to high for printing. I changed this to 0mm but it has the same effect, the Prusa slicer move the z Axis before they go to the start XY coordinates. G92 E0 ;Reset Extruder G1 Z15 F5000 ; lift nozzle M109...

Hello together, i use a Prusa Slicer for my V2.4. i didn't understand how the Print_START macro could be paste into the customer G-Code set, i think it is a syntax error. For now i used this code G28 ; home all axes G1 Z15 F5000 ; lift nozzle G1 X300 Y370 G92 E0 ;Reset Extruder G1 E30 F150...

Yes it is a V2.4 with inductive probe. Thank you BR Steven

Hi all, i have another question ^^. my printer gives me an error message. After Z_ENDSTOP_CALIBRATE Klipper will restart. after i got the error message `position_endstop in section 'stepper_z' must be between position_min and position_max' . When i put it in the printer.cfg position_min: -3...

Yes it is an option i know, but this was what i have at the moment here ^^, it is only a small point of it i think i can lose it when i must

YES they was! One point of superglue at each Stepper drive shaft, at the front of the pully, should solve the problem in future.

Hi there, this thread can be closed it was a slipping pully at the Z1 stepper drive shaft...

Hello Community, my Voron kill my last nerves, after problems with runnig the klicky probe i want to start the gantry leveling. Know i have some troubles that on Z Axis is drifting out of range. i have a suspect to the theeth pully but i can't imagine, because i printed by my self with a...