Recent content by sycs6isYOY

In my post below I describe how I have it connected and working, and my printer.cfg is posted as well. https://forum.vorondesign.com/threads/x-homing-goes-down-y-homing-goes-down-z-homing-goes-up.1119/ "I have Tap installed, voltage (24V) comes from PB7 on the Octopus, but sensor line is...

Yep, that was it. Being new to Klipper I wasn't sure if there was just one global setting to "make Z axis home in the opposite direction" or if each stepper needed to be manually adjusted. To fix the issue, I updated these four sections in the printer.cfg. [stepper_z] [stepper_z1] [stepper_z2]...

I have Tap installed, voltage (24V) comes from PB7 on the Octopus, but sensor line is connected to PG15. The Endstops "Z" and "Probe" read correctly in Klipper when open (toolhead in lowered position) and triggered (toolhead held upwards). Now here is the weird part, when I send the command...