Recent content by Tegguy

Sorry was on travel for work... Will try to print something like this

I didn't see anything in here about dimensional accuracy but I might have missed it

Sorry .5mm on 20mm cube

I am having some issues with some dimensional accuracy on my Voron 2.4 with Revo Hotend 2.4 nozzle. Z axis is almost perfect (less than .1mm off) X and Y axis are both off by around .5 Are there any guides on where to start troubleshooting this?

How does doing something like this or dumping outside affect chamber temps? I currently have the Nevermore installed but the smell is still pretty strong. Perhaps I need to explore better sealing options first

I have found a need to print ABS more often and my printer is currently located in a spare bedroom. ABS fumes and smell have become a concern... How has other people managed to control the fumes without impacting chamber temps?

Good idea. It's where it passes through the threaded push to connect fitting. I'm not sure if it's the fitting or the housing the fitting threads into I need to look at it closer

I have a Voron 2.4 LDO kit that I recently built but it seems like the feedtube is causing layer issues with my prints with randomly missing material (remove feed tube and the issues are gone). Brand new filament and it appears to be the correct material. Doe anyone have any insights into the...

figured it out... looks like wrong model on the website.

I have a stupid question but I can't find any pictures/documentation... I have a 2.4 LDO kit with the LDO mount for stealth burner and I can't seem to figure out where to attach the input shaper mount to. Can someone help me out?

I've tried both smooth and textured. I will try Dish soap and hot water... I've been doing IPA before each print currently. I had an issue with ABS sticking too good to the smooth sheet and that's what send me down this path and now I think I've changed the wrong setting somewhere and am...

Thanks I'll keep struggling through this. Can't understand why I can't get the filament to stick to the bed... so frustrating

So at cold z= 0 at .1mm would be correct? I'm fighting with ABS and getting it to stick to the bed.

So having the z 0 location as actually.1mm is correct? Should preface that im a total newbie with printing and everything so I've never even used the Z adjust during the print

So I'm close but still not sure if I'm there.... When I do the Z_offset_calibration and do the paper test do I leave the nozzle .1MM above the bed or do I remove the paper and drop down .1mm before accepting? The reason I ask is becuase right now when I manually move the nozzle my Z is 0 when...