Recent content by thespacecowboy

Having this problem with a nitehawk randomly. I have spares but has anyone determined what is going on? Make that both nitehawks, suddenly.... ????

I did try to work with them, they are ALMOST there. I see what they want to do and there's no reason with what they are capable of that they can't do it. It's really just an organizing things problem. Hindsight being what it is I should have gone with PIF or just printed my own, as the stuff I...

Thank you, and through what resource did you locate this?

I got the LDO Rev D kit, and printed parts from MH, but the excess of parts is definitely on the MH end. I figured the front side plate would fit with the 350 back center plate on the rear, since I don't see a different rear side plate besides the one for the power jack. Any parts I printed...

Quite frankly the official VORON 2.4 guide is back on Rev A or some old version. There are dozens of things in here that are not involved with, or part of, any kit available today. For example, the nevermore filter is more or less standard now, and the 2.4 guide has rear filter instructions...

Please get this in order. I should not have to waste 250 grams of plastic printing stuff that doesn''t fit the latest revision. That revision should not be released until YOU HAVE BUILT AN ENTIRE PRINTER YOURSELVES FROM YOUR OWN INSTRUCTIONS For example the switch plate is reversed for a single...

I did that with a spare one that happened to be right, but I have no idea what type they are specifically and trying to order and size them without knowing that already I failed at. The one I made is wonky and I also could just use pin jumpers but none of those things are ganna fit in the...

I can for now rig the connection, but I need a cable designed to go from the nitehawk usb toolboard to the tap sensor, on the stealthburner, and I need it to be the right length and have the right connectors. Where can I get this cable?

My mistake 100%. I plugged it into the wrong port on the nitehawk. My bad! Should anyone else find this, it plugs in on the back.

Everything is set up, and everything attached to the nitehawk works except the extruder. There are no errors thrown by anything that I can see. What should I look at? this is a brand new LDO extruder for clockwork 2 At the nitehawk, I tested the pins for the extruder, black and green have 2.6v...

So my confusion was because the tap kit didn't come with the right connectors. But the LDO kit came with two sets of endstop wires because one is wired wrong, and the wrong one happened to have the right connector for the nitehawk, so I tore one out and hot glued the wires in. It seems like it...

Hello all, I have my LDO 2.4 mostly together and now I need to wire the tap kit. The kit has a pcb, and 3 uncrimped wires coming from the connector on it. Where should I connect these wires? I have reviewed the tap kit manual and LDO guides but they don't seem to explain what these wires from...

looks like too low a bed temp or material requires an enclosure, not sure what material *oh it's ABS. yeah you need bed as high as it can handle up to 100 or 110. Enclosure or draft free space is extremely helpful.

Well, multimeter says that all the frame bolts have continuity to each other. So I'm ganna find a place for it that has continuity to the frame.

This is insufficient cooling. Those towers are like a guy reaching for the sky in a western.