Voron 2.4 tap kit install

[thespacecowboy]

Hello all, I have my LDO 2.4 mostly together and now I need to wire the tap kit.
The kit has a pcb, and 3 uncrimped wires coming from the connector on it.
Where should I connect these wires?
I have reviewed the tap kit manual and LDO guides but they don't seem to explain what these wires from the PCB go to?
I have red and black and green, there is no blue wire.
Do these connect to the nitehawk or? It did come with 2 clip connectors so I think maybe? but how is it wired?

thanks for your help

 

[thespacecowboy]

So my confusion was because the tap kit didn't come with the right connectors.
But the LDO kit came with two sets of endstop wires because one is wired wrong, and the wrong one happened to have the right connector for the nitehawk, so I tore one out and hot glued the wires in. It seems like it will work for a bit as long as I wired it right.
Also busted the wire off the part cooling fan somehow but managed to solder those tiny wires back on. Continuity tests ok.
May have to replace some of this but this may work for now.