Recent content by timmit99

That looks like the sourcing guide which shows you WHERE to find items, and you probably are on a different printers tab on the bottom. Use this: https://vorondesign.com/voron_trident and go tot he Configurator option.

I currently have my V0 living in a pelican flight case so I can check it with me on flights. It's been to Colorado twice, Chicago twice, Maryland once, and a few other places. I use a Pelican Hardigg im2750 that I got on eBay and I bought a new set of foam from B&H and cut it to match the...

Check your menu config (used to flash the display) and make SURE you have the correct USB pins selected. Otherwise it will flash but never talk to klipper!

you 100% will find it there after flashing with klipper as long as the menuconfig is set correctly and you have removed the boot jumper.

Did you remove the boot jumper after flashing? Can you share a screenshot of your `make menuconfig` here?

Just to be 100% clear, you have set the SKR Pico up for USB connections not UART correct?

Hello! So first of all, glad to see this board being used! Second, the board doesnt connect to your SKR Mini. The screen is its OWN control board with the STM32F042 on it =) As such, you would wire up a USB cable to the 4 pin XH header following the labels on the silkscreen and hook it up to...

Especially with the carriage needing two that get pressed down quite far, there could be some callouts for it.