Recent content by Tripslip

My must have list is all the homing and probing parts. I ordered switches and have spares ready to go. full toolhead pulley parts AAAAAnd, if you really want to be safe, all the motion parts. I printed all the core parts and have them in a bag. I have gone into that bag a lot lol.

Well, x-carriage and Klicky PCB rebuild done. I found one other small issue in my cfg. z current was at .4 to quiet it down some. All belts have the same tension but still having a issue with corner #1 and #2. if I cant get this resolved this time I think I am going to start a build from scratch...

My issues are in probing. Once it DOES probe I get fantastic first layers. When probing my readings bounce all over the place and I get "exceeded tried". As for TAP. I noticed something interesting the last time I tried to print with it... When the chamber got hot, the linear bearing got really...

First upgrade/mod was to Euclid. So fa, it was the best results. I had a problem with switches dyeing though. I also tried klicky but felt like I always had to fuss with it. Klicky PCB looks like it is going to fix some of the short comings between both Euclid (not seating properly and shorting...

lol, I'd say you're correct. As you cant probably see be the list of mods, most of them are from trying to fix my main issue, Z consistency. I have tried about everything short of new MCU, power supply and motors (which I am thinking of doing). Most recent changes have been TAP, Pins and new...

Im late in starting a build log as I am pretty much done. I have done quite a few mods and upgrades and have the machine running. But not well at the moment. Here are the specs so far... 2.4, 350, Voronkits.com base with PIF parts. I have reprinted a lot of the parts trying to fix some issues...