Recent content by tx_wombat

After adding the ground I'm at 4+ hours in of printing (1 larger and multiple smaller prints) - and no issues

yes. I'm thinking next of adding additional ground from power supply to board and then the extruder drive.

I had prior - but have since removed the LED's and still having issues. I've reduced he Run_Current on the drivers and it happens 30+ min into a print so nothing is running at 100%

Meanwell LRS-150-24 - which I've swapped out as well - all connections good. also dropped the run_currents even further with no luck.

FYSETC 0.2 R1 - going around and around with Tech support on this one. Has the Catalyst board - prints complete about 1 out of 3 prints. I get various GSTAT errors from either the Extruder (00000001 reset) or X or Y Axis (undervoltage 00000004). replaced the Catalyst board (not drives) and...

this is the ones I ordered https://www.aliexpress.us/item/3256806008931756.html

are you using the stock Z-belt tensioners at all 4 corners? - I'm having similar issues and found that one of mine isnt as stable as I'd like and have since ordered a tool-less CNC version off aliexpress.

Whats the gcode to run this probe test? - I've only seen the basic one before...

as title - 0.2 Pro R1 - Extruder TMC GSTAT 0000001 error.. the extruder run_current is default 0.7 - any info what else it could be or is that wrong?

Working alot better - but still a little stuck.... getting a Klipper shutdown but i'll post a new topic to cover.

Thanks - I'll boot it up today and check those settings.

Nothing based on the github - https://github.com/FYSETC/FYSETC-Voron-0.2-Pro/tree/main/0.2%20R1 Also Y Axis is sensor less and its only on the X that it fails (but it does move at boot) - I assume 0,0 (X,Y) is at back right.... or is this reversed somehow? Z is on a Z-stop and is fine.

New FYSETC 0.2 Pro R1 which uses the Catalyst board pre-loaded etc.. 1. On boot I'm getting a error- No trigger on x after full movement and its pushing the X-Asix into the rear right side constantly - TRying to home but sensorless is not working (should be active by default). Y and Z appears...