What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by vigge7614

  1. V

    Bed mesh issues

    I do a bed mesh every time I start a new print. From what I can see it looks like it is loaded in mainsail
  2. V

    Bed mesh issues

    I am having problems with my freshly built Voron 2.4(LDO 300 mm kit). I always end up with too much squish at the front of the bed and not enough squish at the rear of the bed. Feels like I have tried every different bed_mesh setting. I am using a klicky probe and I don't think it has anything...
  3. V

    SHAPER_CALIBRATE, what axis

    Thanks, I will give it a try tomorrow!
  4. V

    SHAPER_CALIBRATE, what axis

    I have the LDO ADXL extension board and I am using the Stealthburner mount. However my axises marked on the board do not represent the real axes, Z is X, etc. I have done manual configuration with "TEST RESONANCES" using the method in Nero3d's video on youtube. However I want to use the...
  5. V

    Perimeter gaps

    Found the issue, reverted back from Superslicer Arachne to version 2.4 and tuned pa to 0.435, now the gaps are gone and prints are looking nice. Might help someone if they are stuck with the same issue.
  6. V

    Perimeter gaps

    This is the voron test cube with 0.03 pa and 1.00 flow
  7. V

    Perimeter gaps

    Hi! I am having issues while tuning my pressure advance, I have tested all flows between 0.92-1.08 and I am pretty sure this is not the issue. I have tried several different nozzles, and I am currently running a CHT 0.4. I am using Ellis's tuning guide and his pattern method. However, I cannot...
See more
Top