VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by vnomus427
-
V
Question Changed A/B Belts, Now Positioning is Lost During QGL.
Never mind, it turns out my run_currents were too low. I adjusted from .8 (set when I had TMC2209s) to 1.0 for the TMC5160. The change to the new belts must have been enough to trigger the need for the updated values. Maybe this will help someone else....- vnomus427
- Post #2
- Forum: Voron V2.X
-
V
Question Changed A/B Belts, Now Positioning is Lost During QGL.
I changed out the A/B belts on my 2.4R2-350, reset the TMC_Field SGT X/Y values, and after successfully homing All, the QGL no longer works? The printhead moves slightly off-center, accompanied by X/Y steppers making a high pitch noise, and then starts the initial (Z0 corner) check near the bed...- vnomus427
- Thread
- Replies: 1
- Forum: Voron V2.X