VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by Vorandy
-
V
Microcenter Voron Kit(s) Build
Update 3: Some things I have learned about the Microcenter's Voron Kits... if you buy the CNC aluminum kit, you probably don't need the Fastener kit. It has everything you need if you are using printed parts. I didn't keep everything separate so I can't say for sure you "don't" need it. But you...- Vorandy
- Post #5
- Forum: Build Logs
-
V
Microcenter Voron Kit(s) Build
Update 2: Be very careful with this kit. Because I was bouncing back and forth between manuals I missed a step and had to disassemble and reassemble the z-corners. When i retighted the grub screws I stripped the part. I used a sharp pin punch to peen the hole so it had a little bite but that...- Vorandy
- Post #4
- Forum: Build Logs
-
V
Microcenter Voron Kit(s) Build
I've only had one small hardware issue so far, the DIN rails were "exactly the width of the interior of the rails, so no slop to line up the screw holes in the M5 T-Nuts. See below. It was an easy fix, I used a belt grinder to take about 10mm off one end and it gave me enough room to move left...- Vorandy
- Post #3
- Forum: Build Logs
-
V
Microcenter Voron Kit(s) Build
I'm starting my first Voron 2.4r2 (not first printer or first build), Based on Microcenter's Voron Kits, with several deviations from the standard. For those of you who don't know Microcenter now sells a series of kits that allegedly end up as a Voron 2.4 R2. They are not all marked for a 350MM...- Vorandy
- Thread
- Replies: 4
- Forum: Build Logs