VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by voronstress
-
V
Question Nothing Prints? (Toolhead moves, temps are fine), however the filament just doesn't extrude. CW2, SB, TAP, Rapido (Listing my specs for reference)
I will post a few photos of the toolhead, however I tested the extruder independently and im 99% it is not that. (It prints now that I got a new nozzle but I think I need to do a re offset of Z or PROBE calibration since i have TAP, which might fix my first layer issues)- voronstress
- Post #5
- Forum: Slice and Print
-
V
Question Nothing Prints? (Toolhead moves, temps are fine), however the filament just doesn't extrude. CW2, SB, TAP, Rapido (Listing my specs for reference)
I have no idea, (where can you find this info) but it extrudes fine without the hot end. When I tested individually- voronstress
- Post #3
- Forum: Slice and Print
-
V
Question Nothing Prints? (Toolhead moves, temps are fine), however the filament just doesn't extrude. CW2, SB, TAP, Rapido (Listing my specs for reference)
Hello, finally finished my Voron 2.4 R, and after creating a print config and finishing everything in the initial print start guide (z-offset etc.) I am having issues printing. because no matter what I do the filament refuses to extrude, I completely cleaned out my nozzle, and heat tightened the...- voronstress
- Thread
- Replies: 5
- Forum: Slice and Print