Recent content by vukrook

I'm also fine with my Voron. The assembly in 2023 was piece of cake, modding took some reasonable time. Nowadays Formbot's kit has already evolved to a state where I had to bring my printer to by myself. CAN, Klicky, sensorless homing, case lights, 60W heat element. The feature I'm still...

Assume your KAMP_Settings.cfg contains variable_probe_dock_enable: True as well as attach/dettach macro names... Then I'd check and resolve those Unknown command messages @ 21:45 appearing in the console after an attempt of 'Attaching probe' was made @ 21:44. Might be there's some weakness in...

I ran into the very same error message, occurring with EBB36. Finally it was an occasional bad male-to-female connection inside the connector. Re-crimped the pins, then I made a 70mm TPU extension sleeve for the CAN cable a) to precisely attach to the outlet, and b) to mate the cable with EBB38...

Glad to hear the solution was found. Sudden filament feed issues were occurring to my printer, too. After a great deal of checks in vain I took the calipers, measured the filament diameter... and read 1.86mm. In my case it was this trivial. Interestingly more than the first spool half got...

My two cents; might help someone these days, though it's been a while since previous post. Shortcut to the point: 40W heater is not covering heat curve expected by Klipper. Story: The issue first occurred as ambient temperatures dropped below, say, 10°C. To wit, the printer is allocated in a...